| 静电喷枪操作注意事项 |
| 添加时间：2017/9/2 10:42:29 浏览次数： |
| 一、喷涂移动速度。在喷涂作业时，喷枪的移动速度对涂装效果有很大影响。 I. spraying speed. During the spraying process, the moving speed of the spray gun has a great influence on the coating effect. 1、如果手工喷枪移动太快，被涂物表面涂层稀薄，显得干瘦、流平性差、粗拙； 1, if manual spray gun moving too fast, the surface coating material is thin, thin, leveling, coarse; 2、如果手工喷枪移动速度慢，被涂物表面涂膜肯定很后，而且易产生流挂现象。 2, if the manual spray gun moving speed is slow, the coating surface coating must be very after, and easy to produce flow hanging phenomenon. 3、理想的喷枪移动速度是喷涂结束后，被涂物表面涂层饱满、均匀、润湿。这个需要有一定喷涂经验的作业人员才能控制。 3, the ideal spray gun moving speed is the end of spraying, the coating surface coating plump, even, wet. This requires a certain spraying experience of the operator to control. 二、对扳机的控制。喷枪是靠扳机来控制的。扳机扣得越深，液体流速越大。静电喷涂设备在传统走枪的过程中，扳机老是扣死，而不是半扣。为了避免每次走枪行将结束时所喷出的涂料堆积，有经验的喷漆工都要略略放松一点扳机，以减少供漆量。 Two, control of the trigger. The spray gun is controlled by a trigger. The deeper the trigger, the greater the velocity of the liquid. Electrostatic spraying equipment, in the process of traditional gun, the trigger always buckle, rather than half button. In order to avoid the accumulation of every walk at the end of the spray gun spray coating, experienced to slightly relax the trigger, to reduce the amount of paint for. 三、喷枪对基材表面的方位。喷枪对基材表面应该保持垂直，或者尽量保持垂直。假如喷枪有一点歪斜，其结果必定会造成喷幅带偏向一边流淌，而另一边则显得干瘦、缺漆，极有可能造成条纹状涂层。 Three. The orientation of the spray gun on the substrate surface. The spray gun should be vertical to the base surface or as vertical as possible. If the gun has a little askew, the result will cause the spray range with side flow, while the other side is thin, lack of paint, most likely caused by stripe coating. |
| 上一页 液体静电喷枪的好处 |
| 下一页 静电喷枪的组成 |
Copyright © 技术支持：遨游网络