河北静电喷枪厂

在喷涂作业过程中，喷枪操作不当就会影响产品喷涂效果，好的喷涂效果表现在：1、涂层分布平均2、涂层不能过厚不能太薄。

In the process of spraying, improper spraying of the gun will affect the spray effect of the product. Good spraying results are as follows: 1, the coating distribution is 2, the coating should not be too thick and not too thin.

        喷涂需注意的几点问题：

Some problems spray should pay attention to:

        喷嘴出料口与被涂物之间的距离称为枪距。枪距越小，喷涂压力就越大，产品受到气压的冲击也越大，涂层就会出现不平均的情况，产生涂膜过厚的问题。枪距越大，喷涂压力越小，涂料易流失，使被涂物部分喷料过少，涂膜达不到指定的厚度。喷涂扇面与被涂物面呈现垂直的状态。手工操纵喷枪时，喷涂宽度不能出现过大的情况，否则会出现涂层平均的问题。喷枪运转的目的要始终与被涂物面平行，与喷涂扇面垂直，运转速率不稳，涂层厚度不平均，运转速率过快涂层太薄，运转速率过慢涂层太厚。总而言之，在使用喷涂设备的时候，要做到力度适中，距离合适才可以，这样才能够得到想要的涂装效果，在施工后，一些扫尾的事情也需要完善起来，涂料及帮助器具的收拾，使用后的残剩涂料要封锁保留，这都是需要注意的问题。

Nozzle between the material outlet and the coated distance called gun distance. The smaller the gun distance is, the bigger the spray pressure is, the more the product is impacted by the pressure, the less average of the coating will occur, and the problem of too thick coating will be produced. The larger the gun distance, the smaller the spray pressure, the coating is easy to drain, so that the coating part of the spray is too little, the coating can not reach the specified thickness. Spray fan and the coated surface presents a vertical state. When the spray gun is manipulated manually, the width of the spray can not be too large, otherwise the problem of the average coating will appear. The gun running to always be parallel with the surface coating, spray fan vertical, speed instability, coating thickness is the average speed is too fast, the coating is too thin, too thick coating speed is too slow. In short, when using the spraying equipment, to achieve moderate intensity, proper distance can, so that we can get to the coating effect, after construction, some outstanding things will need to be perfected, and help clean up paint equipment, after the use of the remaining paint to block retained, it is need to pay attention to the problem.

         喷涂作业需要注意的事项包括：喷涂移动速度、扳机的控制、枪距还有握枪姿势等等。

Spraying operations need to pay attention to matters including: spraying speed, trigger control, and hold the gun away from the gun position, etc..